Calibration Services
Swanson Tool Manufacturing’s calibration service is a source for certification of your gages to meet your quality requirements. Inspections are performed by trained metrology personnel using procedures that comply with ANSI/NCSL Z540-1, ISO-17025 and ISO10021-1 in an environmentally controlled laboratory. Primary master reference standards are directly traceable to the National Institute of Standards and Technology (NIST).
By utilizing our calibration service, you get one-stop shopping for all your gage requirements. If a gage is determined to be out of tolerance and can be reworked, you have the option to have the gage reworked for 50% the cost of new and not be charged for the original calibration. If the gage can’t be reworked and needs replacing, you have the option to replace it with a new Swanson gage and again not be charged for the original calibration.
- Thread Plug Gages (work or master)
- Thread Ring Gages
- Taper Thread Plug Gages
- Taper Thread Ring Gages
- Plain Cylindrical Plugs
- Plain Cylindrical Rings
Certificates of Calibration
Swanson Tool also offers Certificates of Calibration (our Long Form Certificate) traceable to the National Institute of Standards and Technology (N.I.S.T.). These certificates report a gage’s specified and actual measurements and are available for both new gages and gages sent in for calibration.
Download Our Precision Thread & Plain Gage Catalog
Download Gage Calibration Service PDF › Download Full Catalog PDF ›